Update will change the boot up screen to airtvĬaution EPG is not working properly in V6. NTFS pre-formatted drive now accepted for recording Receiver will reboot once update is completed Wait for update to proceed to blue screen and 100% complete message. Proceed to menu > system > software udate Proceed to menu > system > Restore Factory Default password 888888Ĭopy the "usb_upgrade_all_flash.bin” to a FAT32 formatted drive. Of course if this is your objection you could also go with the Ematic AT103B which comes with corrected firmware right out of the box. The best feature of this box is that you can operate the Axess CB-3001 in the same environment as the Iview 3500stbii and the Homeworx HW150PVR since the three remotes operate on independent and non conflicting remote codes. This same style remote is used for the ematic at103b but the remote board is programmed differently and thus only about 2/3 of the keys are identical. Remote key pad next to SL DT-1200 remote which uses same remote board but different keypad. Only the new version of the Iview 3500stbii with the ch 3/4 switch uses the same msb1237 demodulator chip so the original iview and homeworx firmwares are not compatible with the sunkey boxes because they used a samsung S5H1411 demod chip.įront and back of remote control for CB-3001 and AirTV same remote board also used for NT-52, DT-1200 But there are many hardware and software differences to consider. This box uses the MSTAR MSD7816 chip like the Iview 3500stb, Home HW150PVR, Ematic at103b, ViewTV AT-163, Proscan PAT-102, QFX CV-100, Stellar Labs DT-1200, Stellar Labs DT-800, Naxa NT-52, Supersonic ikonvert SC-56 and SC-58. Only difference I could find is the boot screen logos Notice both factory firmware screens state Lutema AirTV V4 factory firmware system info Most likely also works with the Supersonic ikonvert SC-57 box, but I cannot personally verify this so if you own a SC-57 please post your system info screen here first for comparison with HW version.Īxess CB-3001 V4 factory firmware system info There is a new firmware V6 that replaces the V4 from the factory.Ĭorrects the original factory V4 firmware bugs that add 5 days to a daily and weekly timer event,Īllows use with computer formatted NTFS discs.īut EPG only shows info for current and next programĬontains the logo for the Lutema AirTV but also works with the more common Axess CB-3001, I have tested it on that box.Īfter upgrade remote control, front panel light and buttons function properly. New thread for support of SK-903H based boxes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |